Analog-way Pulse Uživatelský manuál stáhnout pdf (Strana 46)

1/ Connect a DB9 M/F straight cable between the PLS300 and your

PC, then power on your devices.

2/ Click on the RCS program le on your PC to run the software.

3/ Click on the “Connections” tab and select RS232 as the connection

type. In the drop-down menu, select the COM port number

corresponding to the connected device (default is Port 1).

4/ Click apply, and wait for devices to synchronize. The RCS will

display the following connection message: “Device Connected”

5/ Click on the “Connections” tab to return to the main screen.

1/ Connect a crossed RJ45 cable between the PLS300 and your

PC, then power on your devices. Use straight RJ45 if connecting

through a network switcher.

2/ Click on the RCS program le on your PC to run the software.

3/ Click on the “Connections” tab and select TCP as the connection type.

4/ In the “Remote Address” eld, enter the IP address of the PLS300

you wish to control (see also “Working with the PLS300”).

5/ In the “Remote Port” eld, enter the remote port number of the

PLS300 you wish to control (see also “Working with the PLS300”).

6/ Click Apply, and wait for devices to synchronize. The RCS will

display a connection message.

7/ Click on the “Connections” tab to return to the main screen.

Serial connection

Ethernet connection

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 57 58

Žádné komentáře

Analog-way Pulse Uživatelský manuál Strana 46