Analog-way HD Scan AG/DG - XTD920 Uživatelský manuál stáhnout pdf (Strana 17)

HD SCAN™

PAGE 17

Chapter 10 : CONTROL SOFTWARE

10-1. CONNECTION

• CONNECTING THE RS-232:

Connect the serial port of your control device to the REMOTE CONTROL (RS-232) connector (DB 9 Female) of the

HD SCAN

™

with a straight cable (DB 9 Female / DB 9 Male).

• PIN-OUT:

PIN # FUNCTIONS

2 TRANSMIT DATA (Tx)

3 RECEIVE DATA (Rx)

5 GROUND (Gnd)

DB 9 female

(Rear panel of the HD SCAN

™

)

• SPEED TRANSMISSION: 9600 bauds, 8 data bits, 1 stop bit, no parity bit, no flow control.

10-2. "HD SCAN REMOTE CONTROL" SOFTWARE

Your HD SCAN

™

is shipped with a WINDOWS 95/98/2000/Me/XP compatible "HD SCAN

™

REMOTE CONTROL"

software (3.5" disk). This software allows you to control and make adjustments by a simple mouse click (output format,

image adjustments, etc...).

• SOFTWARE INSTALLATION:

c Turn your computer ON and wait for Windows to completely start.

d Insert the CD-ROM into your drive: the ANALOG WAY home window will open automatically.

e Select the language of the CD-ROM menus, then click on "Install a Remote Control Software" and select the name

of your device.

IMPORTANT:

If the Autorun is not enabled: From the Windows desktop, open My Computer and select the CD-

ROM drive. Select the Autorun folder, then select the autorun.exe file.

f Follow the Windows installation instructions.

• STARTING UP:

c Connect the RS-232 cables between the control device and the HD SCAN

™

as indicated in section 10-1.

d Then only power ON all of the devices.

e Click on the program files XTD920 in Start-program-ANALOGWAY-HD SCAN to run the software.

f Click on Controls menu and select the Serial port.

The HD SCAN

™

is now controllable by the computer.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 42 43

Komentáře k této Příručce

Žádné komentáře

Analog-way HD Scan AG/DG - XTD920 Uživatelský manuál Strana 17

Komentáře k této Příručce

Související produkty a manuály pro Audio Analog-way HD Scan AG/DG - XTD920