Analog-way VERTIGE - Ref. VRC300 User Manual Uživatelský manuál stáhnout pdf (Strana 15)

4.1.1 System conguraon

4. STARTING WITH THE VERTIGE™

4.1.1 System conguraon

4.1 Operaonal conguraon

When the Verge™ starts up, the Home page is automacally displayed. Press the START buon, then

press the Verge™ SETTINGS buon in the upper-right corner.

The Verge™ Sengs page allows you to congure the IP address of the Verge™ and update it via a USB

port:

• Conguring the network:

In the top bar, select the Network Editor

tab. Select the Ethernet port used by the

Verge™ on your network then enter

the corresponding IP address, subnet

mask and gateway. When ready, press

the Apply buon.

• Updang the rmware:

In the top bar, select the Firmware

Updater tab. The upper area displays the

current rmware version. Make sure the

USB ash drive you are using contains

an up-to-date version of the Verge™

rmware. Plug this USB ash drive into

one of the Verge™ USB connectors.

Wait for the device to appear in the

Storage list then select it to display the

rmware updaters available. Select the

desired update from the list then press

the Update buon to start updang the

Verge™.

IMPORTANT: Do not remove the USB ash drive or turn o the power while updang.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 43 44

Žádné komentáře

Analog-way VERTIGE - Ref. VRC300 User Manual Uživatelský manuál Strana 15