
20
The Audio Edit tab will give access to audio in/out parameters such
as levels, balance or volume.
The Edit Sources tab allows to map device inputs, logos or frames to
source buttons on the ORCHESTRA front panel.
1/ In the Screen Setup page of the ORCHESTRA, press Edit
Sources. The buttons in the Source Preview section of the
ORCHESTRA will light up, allowing you to select the source
you wish to work with.
2/ Select the source you wish to parameter, then press Edit to
* NOTE * : If you are working with a matrix, you can map matrix inputs
Input Conguration
chapter and the Working With A Matrix chapter).
3/ The Enable
activate sources. De-activating a source will result in an
inaccessible button on the ORCHESTRA front panel.
Audio conguration
Source conguration
Soft Edge Setup
The Edit Soft Edge tab will be available if the connected slave device
Di-
VentiX II) or if several units has been added to the screen for a
multi-univ SEB.
* NOTE * : For more details on Soft Edge Blending, please refer to
the Soft Edge Blending chapter of this manual
1/ In the Screen Setup page of the ORCHESTRA, press Edit Soft
Edge.
Soft Edge Setup
control and adjust your Soft Edge. Press on Soft Edge Type to
You can also position the devices within the screen by scrolling
with the appropriate knob left or right.
3/ Press the Covering tab to control the amount of Soft Edge
amount of image covering on your Soft Edge.
Komentáře k této Příručce