
106
10.2 Associave Modularity mode
Dierent Livecore models can be linked together. When linked, both devices assume the capabilies of the
lesser unit. To link two dierent models together, iniate the link from the lesser unit.
This mode requires a Verge console. In this mode, all live video sources must be split and shared with the
Livecore units using a splier, matrix router, etc, and the Livecore Link cables are not used. The Device Sync
cables are used to share control and ming informaon between the units. Control of the units is managed
by the console through the LAN network.
In cases where the blended screen involves more than one LiveCore™ unit device, it becomes desirable to
improve the synchronizaon or eects and transions between the mulple units, to ensure the consistency
of any moving images which cross the boundary between devices. The LiveCore™ unit oers a pair of Device
Link ports for this purpose.
To use the Device Link Sync feature in any mul-device setup, you will need one standard straight CAT5
ethernet cable. Start by connecng the Cat5 cable from the Device Link output RJ-45 jack of device 1 to the
Device link input RJ-45 jack of device 2.
1/ Up to 2 devices can be connected using Device Link.assembled in Addive Modulaty Linked mode. Up to
4 devices can be synced and controlled by the Verge in Associave Modularity mode.
2/ The Cat5 based Device Link does not pass any video picture informaon. This link can only be used to
synchronize is used to exchange the ming of eects and processing informaon betweenon a LiveCore™
unit devices used as part of the same mul-device screen blend (Hard Edge and So Edge). Video
informaon should be shared using a set of specic Analog Way Livecore Link cables.
3/ The console is compable with mul-device conguraon.
Straight RJ45 cable
Device 1 Device 2
Komentáře k této Příručce